N20 Fuel Solenoid Problem

[ratgp]

Anyone ever have a noid, into the cylinders? I had this lovely experience this evening and right now I am feeling like this:piss: :purge: All motor for me, I know I am sure it will pass but it dumped enough into my intake to lock it up when I tried spinning it over with the starter.

[VanillaMtrsprts]

Are you saying that the fuel noid was stuck open?

If so, then just swap it out or rebuild it...


Vanilla

[ratgp]

Yes it was sticking, I am a newbie with spray, is it okay to rebuild the noids or should I replace. BTW the kit is only 6mos old, and has had one N20 run and 3 NA runs thas it. I highly doubt this is normal, it got late last night I was gonna check my reg going to the noid to see if it was damaged, I have had concerns whether or not that cheapie holley style reg., could control the pressure of my Product Engineering pump. Either way I woudl think the solenoid should hack it, anyway thanks for any input.

[TuffGuy]

Do you run a fuel filter ?? The holley regulator is fine.

Rebuild or replace the solenoid. Havent had any experience w/ NX stuff , Use a NOS brand solenoid

[ybaslo1]

If you just installed the solenoid, check and make sure you didn't put in on backwards. Also, if it is a solenoid that has purge provisions (port on each side and one on the bottom), ensure it is installed (hooked up) correctly.

[VanillaMtrsprts]

Rat,

Give me a buzz if you want... 217-202-1246



Vanilla