PDA

View Full Version : Anyone using a Mallory Digital VIIC?

ratgp
08-14-2006, 06:42 PM
If so how did you run your main power wire to the box? Did you go to your remote starter solenoid or did you run straight back to the battery side of your cutoff switch?
Jason Hart
08-14-2006, 06:55 PM
If so how did you run your main power wire to the box? Did you go to your remote starter solenoid or did you run straight back to the battery side of your cutoff switch?

I ran a 667c digital & ran it seperate. as long as you have a large battery cable going to the solenoid from the battery it will be fine taping in there but I didnt want to rob ANY power from the starter.
ratgp
08-14-2006, 07:06 PM
I was concerned that if it was hooked to the "car" side of the switch it wouldn't "save" the memory. Did you have a straight run to the battery on your Chevelle or did you run it to the "car" side of the switch.
Jason Hart
08-14-2006, 11:04 PM
I was concerned that if it was hooked to the "car" side of the switch it wouldn't "save" the memory. Did you have a straight run to the battery on your Chevelle or did you run it to the "car" side of the switch.

It will keep memory, at least mine did. Not 100% but I think I went to the battery. I had the battery out of the car many times & never had to reset the settings.
Newbomb
08-15-2006, 02:22 AM
jason, you've wrenched before? :think: :dunno:
Jason Hart
08-15-2006, 05:47 PM
jason, you've wrenched before? :think: :dunno:

Shadup before i put one on ya with my stock Mustang!!!